Witeam Commercial (Int'l) Ltd    首页 > Products & Service > Boiler > Circulating Fluidized Bed Boiler > 正文 Back Printing

75T/H Medium Temperature Separating Circulating Fluidized Bed Boiler

  2011-05-10 13:55:30  

Circulating Fluidized Bed BoilerThe boiler is of outdoor arrangement, which is made of two vertical shaft type chimney flues at the front and rear parts. The front vertical shaft adopts all-suspension structure from and the walls at four sides are of membrane wall. Arranged from the top to bottom  are primary air chamber, air distribution device, combustion chamber dense phase zone, dilute phase zone, generating tube bank, high temperature and low temperature super-heater and flue gas diversion chamber. The vertical shaft at the rear part is of supporting structure, in which coal economizer and steel pipe horizontal air pre-heater are installed. The two vertical shafts are connected by two cyclone separators in parallel arrangement, with the bottom parts of the separator connected with feed back devices. Both the separator and feed back device are supported by steel structure beams.

The front vertical shaft uses pipe type furnace wall, provided with metal armor board. The rear vertical shafts adopts lightweight armor board furnace wall. Wear-resistant linings are provided in combustion chamber, door-opening zone inside the boiler, smoke window zone at the front wall vertical shaft outlet and inside the separator.

Boiler drum is suspended on the large plate girder by boiler drum suspension rod, with 6 sectional steel columns supporting the whole weight of the boiler. Lightweight structure rainshelter is provided at the top of the boiler.